46 CFR § 199.70 - Personal lifesaving appliances.
(a) Lifebuoys. Each vessel must carry lifebuoys approved under approval series 160.150 as follows:
(1) Stowage. Lifebuoys must be stowed as follows:
(i) Each lifebuoy must be capable of being rapidly cast loose.
(ii) No lifebuoy may be permanently secured to the vessel in any way.
(iii) Each lifebuoy stowage position must be marked with either the words “LIFEBUOY” or “LIFE BUOY”, or with the appropriate symbol from IMO Resolution A.760(18).
(iv) Lifebuoys must be so distributed as to be readily available on each side of the vessel and, as far as practicable, on each open deck extending to the side of the vessel. At least one lifebuoy must be located near the stern of the vessel. The lifebuoys with attached self-igniting lights must be equally distributed on both sides of the vessel.
(v) At least two lifebuoys, each with attached self-activating smoke signals, must be stowed where they can be quickly released from the navigating bridge and should, when released, fall directly into the water without striking any part of the vessel.
(2) Markings. Each lifebuoy must be marked in block capital letters with the name of the vessel and the name of the port required to be marked on the stern of the vessel under § 67.123 of part 67 of this chapter.
(3) Attachments and fittings. Lifebuoys must have the following attachments and fittings:
(i) At least one lifebuoy on each side of the vessel fitted with a buoyant lifeline that is—
(A) At least as long as twice the height where it is stowed above the waterline with the vessel in its lightest seagoing condition, or 30 meters (100 feet) in length, whichever is the greater;
(B) Non-kinking;
(C) Not less than 8 millimeters ( 5/16 inch) in diameter;
(D) Of a breaking strength which is not less than 5 kiloNewtons (1,124 pounds-force); and
(E) Is, if synthetic, a dark color or certified by the manufacturer to be resistant to deterioration from ultraviolet light.
(ii) At least one-half the total number of lifebuoys on the vessel must each be fitted with a self-igniting light approved under approval series 161.010. The self-igniting light may not be attached to the lifebuoys required by this section to be fitted with lifelines.
(iii) At least two lifebuoys on the vessel must be fitted with a self-activating smoke signal approved under approval series 160.157. Lifebuoys fitted with smoke signals must also be fitted with lights.
(b) Lifejackets. Each vessel must carry lifejackets approved under approval series 160.155, 160.176 or 160.177. If the vessel carries inflatable lifejackets, they must be of the same or similar design and have the same method of operation.
(1) General. Each vessel must carry a lifejacket for each person on board, and in addition—
(i) A number of lifejackets suitable for children equal to at least 10 percent of the total number of passengers on board must be provided, or such greater number as may be required to provide a lifejacket of suitable size for each person smaller than the lower size limit of the adult-size lifejacket; and
(ii) A sufficient number of lifejackets must be carried for persons on watch and for use at remotely located survival craft stations.
(2) Stowage. Lifejackets must be stowed as follows:
(i) The lifejackets must be readily accessible.
(ii) [Reserved]
(iii) The lifejackets stowage positions must be marked with the words “ LIFEJACKETS” or “CHILD LIFEJACKETS” as appropriate, or with the appropriate symbol from IMO Resolution A.760(18).
(iv) The additional lifejackets for persons on watch required by paragraph (b)(1)(ii) of this section must be stowed on the bridge, in the engine control room, and at other manned watch stations.
(v) Where, due to the particular arrangements of the vessel, the lifejackets required by paragraph (b) of this section may become inaccessible, alternative provisions must be made to the satisfaction of the OCMI that may include an increase in the number of lifejackets to be carried.
(3) Markings. Each lifejacket must be marked—
(i) In block capital letters with the name of the vessel; and
(ii) With Type I retro-reflective material approved under approval series 164.018. The arrangement of the retro-reflective material must meet IMO Resolution A.658(16).
(4) Attachments and fittings. Lifejackets must have the following attachments and fittings:
(i) Each lifejacket must have a lifejacket light approved under approval series 161.112 securely attached to the front shoulder area of the lifejacket.
(ii) Each lifejacket must have a whistle firmly secured by a cord to the lifejacket.
(c) Rescue boat and marine evacuation system immersion suits or anti-exposure suits—(1) General. Each vessel, except vessels operating on routes between 32 degrees north latitude and 32 degrees south latitude, must carry immersion suits approved under approval series 160.171 or anti-exposure suits approved under approval series 160.153 of suitable size for each person assigned to the rescue boat crew and each person assigned to a marine evacuation system crew.
(2) Stowage. Immersion suits or anti-exposure suits must be stowed so they are readily accessible. The stowage positions must be marked with either the words “IMMERSION SUITS” or “ ANTI-EXPOSURE SUITS” as appropriate, or with the appropriate symbol from IMO Resolution A.760(18).
(3) Markings. Each immersion suit or anti-exposure suit must be marked in such a way as to identify the person or vessel to which it belongs.
(4) Attachments and fittings. Immersion suits or anti-exposure suits must have the following attachments and fittings:
(i) Each immersion suit or anti-exposure suit must have a lifejacket light approved under approval series 161.112 securely attached to the front shoulder area of the immersion suit or anti-exposure suit.
(ii) Each immersion suit or anti-exposure suit must have a whistle firmly secured by a cord to the immersion suit or anti-exposure suit.
(d) Lifejacket, immersion suit, and anti-exposure suit containers. Each lifejacket, immersion suit, and anti-exposure suit container must be marked in block capital letters and numbers with the quantity, identity, and size of the equipment stowed inside the container. The equipment may be identified in words or with the appropriate symbol from IMO Resolution A.760(18).