7 CFR § 42.141 - Obtaining Operating Characteristic (OC) curve information for skip lot sampling and inspection.
The Operating Characteristic (OC) curve information (probability of acceptance) for skip lot sampling and inspection procedures described in § 42.121 is easily obtained from the single curve in § 42.142. The procedure for using the curve in § 42.142 is as follows:
(a) Select any sampling plan for normal condition of container inspection from Table I or Table I-A of § 42.109.
(b) For a given Quality of Submitted Lots, 100p, find the Percent of Lots Expected to be Accepted, Pa from the respective OC curve in § 42.140.
(c) Refer to § 42.142 with this Percent of Lots Expected to be Accepted, Pa, and read the new Percent of Lots Expected to be Accepted, Pas, which results when using these skip lot procedures.
1 This slight increase of Pas over Pa results because all the lots offered for inspection are no longer being inspected. Some lots are being “skipped”, and thereby accepted, which would have been rejected if inspected. The largest increase in Pa which will occur using skip lot sampling is approximately 4 percent. It is for this reason that skip lot sampling procedures are applied only in instances where past production quality has been consistently high—as evidenced by the requirement to have 10 consecutively acceptable lots prior to a reduction in sampling rate—and where all requirements in § 42.120 also have been met.