Ala. Admin. Code r. 535-X-11-.02 - Definitions
(1) As used in this
regulation the Commission hereby adopts and incorporates by reference thereto
the definitions in Code of Ala. 1975, §
24-4A-2(1) -(19).
(2) In addition, the
following terms shall have the meaning ascribed to them by this section:
(a) Commission - The Alabama Manufactured
Housing Commission or its delegate.
(b) Modular Manufacturer - Any person who
manufactures manufactured buildings and shall include the manufacturer, factory
branch, or factory representative.
(c) Modular Retailer - Any person other than
a modular manufacturer, as defined in this section, who is duly licensed to
sell or lease manufactured buildings.
(d) Park Model - A recreational park trailer,
built on a single chassis, and having a gross trailer area of 400 square feet
or less in the set-up mode when measurements are taken on the exterior of the
trailer. The square footage includes all the siding, corner trim, molding,
storage space, and area enclosed by windows, but not the roofing overhang. A
park model is not a permanent dwelling. It is temporary living quarters for
recreational, camping, travel, or seasonal use.
(e) Installation Site - The location where
the manufactured building is installed after it has been purchased and/or
leased by a consumer from the retailer.
(f) Modular Installer - A person certified by
the Commission to install a manufactured building.
(g) Pre-Engineered Metal Building - A small
metal building used for residential storage of open construction without
insulation, electrical, plumbing, heating or utility service lines.
Notes
Author: Jim Sloan
Statutory Authority: Code of Ala. 1975, §§ 24-4A-3, 24-6-4.
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.