8 AAC 80.060 - Inspection and stamping
(a) Upon completion
of installation, a boiler or unfired pressure vessel covered by
AS
18.60.180 must be inspected by a deputy
inspector or special inspector and identified by state vessel number assigned
by the department.
(b) The state
vessel number shall be affixed as follows:
(1)
except as provided in (2) of this subsection, a steel boiler or unfired
pressure vessel will be stamped, preferably on the nameplate, with at least
five-sixteenths-inch numbers; the stamping must be plainly visible and easily
read;
(2) paint marker pens may be
used if they are designed to make notations that are permanent and readable;
the state vessel number must be placed above or below the manufacturer's
information nameplate;
(3) during
the initial inspection and each subsequent periodic inspection,
(A) the responsible inspector shall affix an
inspection tag provided by the department;
(B) the inspection tag must set out
(i) the state vessel number;
(ii) the name of the responsible
inspector;
(iii) the responsible
inspector's identification number as it appears on the card issued under
8 AAC 80.040, if the responsible inspector is a special
inspector; and
(iv) the month and
year in which the inspection was performed; and
(C) the inspection tag must be replaced at
each subsequent periodic inspection.
Notes
Authority:AS 18.60.180
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.