7 CCR 1101-14-1.5-3 - Refined Fuels Vehicle Tank Meter (VTM) Inspection and Testing

(a) All refined fuels vehicle tank metering systems shall be suitable for their intended use, properly installed and accurate, and shall be maintained in that condition by their owner/operator.
(b) All refined fuels vehicle tank metering systems shall have an active National Type Evaluation Program (NTEP) Certificate of Conformance (CC) prior to their installation or use for commercial purposes.
(c) The division shall be notified when any new or remanufactured refined fuels vehicle tank metering system is placed in service at a new or existing installation.
(1) Notification shall be submitted using a placed in service report provided by the division.
(d) No owner/operator of any refined fuels vehicle tank metering system shall use the meter for the measurement of fuel products unless it has been proved in a manner acceptable to the Director of the division and sealed as correct by a state inspector or registered service agency.
(e) If any refined fuels vehicle tank metering system fails to comply with any of the provisions of these regulations, a state inspector shall seal it in such a manner as to prohibit its use, and it shall remain sealed until it complies with all of the provisions of these regulations.
(1) When a refined fuels vehicle tank metering system is brought back into compliance with these regulations, it must be placed back in service by a state inspector or registered service agency.
(f) All refined fuels vehicle tank metering systems shall comply with the minimum standards as prescribed by the applicable sections of NFPA 385, NFPA 30A, NIST Handbook 44, and NIST Handbook 130 except as modified or rejected by these regulations or by the division.
(g) All refined fuels vehicle tank meters shall be labeled in accordance with the minimum standards as prescribed by the applicable sections of NFPA 385, NFPA 30A, NIST Handbook 44, and NIST Handbook 130 except as modified or rejected by these regulations or by the division.
(h) All refined fuels delivery trucks used to carry fuel products shall prominently display on the truck, in letters at least three inches in height, the name and address of the owner or operator.
(i) All refined fuels delivery trucks shall display prominently on the rear of the tank the appropriate DOT placard for the product contained.

Notes

7 CCR 1101-14-1.5-3
37 CR 18, September 25, 2014, effective 10/15/2014 39 CR 18, September 25, 2016, effective 1/1/2017 40 CR 05, March 10, 2017, effective 5/1/2017 40 CR 07, April 10, 2017, effective 5/1/2017 41 CR 07, April 10, 2018, effective 5/1/2018 42 CR 04, February 25, 2019, effective 3/17/2019

State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.


No prior version found.