Conn. Agencies Regs. § 14-99g-5 - Compliance sticker requirements. Instructions
(a) The
manufacturer shall submit to the commissioner, for approval, a sample of a
compliance sticker used in the identification and certification of compliance
of each type of sunscreening material submitted in accordance with Section
14-99g-4.
(b) Each compliance sticker shall have on its
face side a pressure sensitive adhesive and opaque lettering, as provided in
subsection (c) of this section, affixed on a contrasting colored background of
any color except that of light yellow. The sticker shall be designed to be
self-destructive, and to display either the word "VOID" or some other clearly
visible indicia of removal, if such sticker is removed after application to a
surface.
(c) Each compliance
sticker shall have the following information imprinted thereon:
(1) The manufacturer's name or
trademark;
(2) A sticker
registration number assigned by the commissioner;
(3) A statement of compliance with "DMV Reg.
Sec. 14-99g-5 " or equivalent; and
(4) The word "REAR ONLY" when supplied with
any sunscreening material which, when combined with the vehicle glazing, would
be suitable only for use on the rearmost window, pursuant to subdivisions (1)
and (2) of subsection (c) of Section
14-99g-2.
(d) Each compliance sticker shall
be designed to be legible, after application to a sunscreening material, to a
person who has a visual acuity of no worse than 20/40 (Snellen), corrected or
uncorrected, from the outside of the vehicle when viewed from a distance of
three (3) feet from the outside surface of the glazing, approximately
perpendicular to the glazing surface. A light transmittance of thirty-two
percent (32%) or higher through the window, as measured in accordance with the
inspection standards, shall be conclusive evidence of legibility.
(e) Each sticker shall be one (1) square inch
in area and square or rectangular with a dimension of no more than one and six
tenths inches (1.6") along its longest side.
(f) Each manufacturer shall also submit to
the commissioner a copy of all instructions supplied with its sunscreening
material. Such instructions shall indicate that the adhesive face of a
compliance sticker shall be applied to the interior surface of the sunscreening
material at the lower left corner as viewed from outside the vehicle.
Notes
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.