Md. Code Regs. 26.13.02.11-1 - Equipment and Procedures-Bureau of Explosives' Test Apparatus
A. This regulation
describes the equipment and procedures that shall be used in evaluating the
criteria of Regulation .11C(3)(c)(ii)-(iv) of this chapter to determine whether
an aerosol is ignitable.
B. Flame
Projection Test.
(1) Equipment. The test
equipment for the Flame Projection Test consists of a base 4 inches wide and 2
feet long. A 30-inch rule with inches marked is supported horizontally on the
side of the base and about 6 inches above it. A plumber's candle of such height
that the top third of the flame is at the height of the horizontal rule is
placed at the zero point in the base.
(2) Procedure. The test is conducted in a
draft-free area that can be ventilated and in which the atmosphere can be
cleared between each test. The self-pressurized container being tested is
placed at a distance of 6 inches from the ignition source and the spray is
jetted into the top third of the flame with the valve opened fully for periods
of 15 to 20 seconds. The length of the flame projection from the candle
position is read on the horizontal scale. Three or more readings are taken on
each sample and the average of the readings is taken as the result of the test.
Samples are also tested with the container valve in partially open positions to
test for "burning back" to the valve.
C. Drum Tests.
(1) Equipment. The equipment for the open
drum test and the closed drum test consists of a 55-gallon open-head steel drum
or similar container that is placed on its side and fitted with a hinged cover
over the open end that will open at a pressure of 5 pounds per square inch. The
closed or solid end of the container is equipped with one shuttered opening at
the top. The shuttered opening is for the introduction of the spray being
tested. The opening is approximately 2 inches from the edge of the drum head
and is 2 inches in diameter. There is a safety glass or plastic window 6 inches
square in the center of the solid end. A lighted plumber's candle is placed
inside the drum on the lower side and midway between the ends.
(2) Drum Test Procedures.
(a) The Open Drum Test and the Closed Drum
Test shall be conducted in the open and when the temperature is between 60°F
and 80°F.
(b) Open Drum Test. This
test is conducted with the hinged end of the test equipment in a completely
open position and with the shutter closed. The spray from the dispenser of the
item being tested, with valve opened fully, is directed into the upper half of
the open end and above the ignition source for 1 minute. Any significant
propagation of flame through the vapor-air mixture away from the ignition
source shall be considered a positive result, except that any minor and
unsustained burning in the immediate area of the ignition source is not
considered a positive result.
(c)
Closed Drum Test. This test is conducted with the hinged cover of the test
equipment dropped into position to rest freely against the end of the equipment
and to close the open end of the drum to make a seal that is reasonably secure,
but not necessarily air-tight. The shutter is opened and the spray is jetted
into the drum through the shutter with the valve fully opened for 1 minute.
After clearing the atmosphere in the drum, the jetting is repeated similarly
three times. Any explosion or rapid burning of the vapor-air mixture sufficient
to cause the hinged cover to move is considered a positive result.
Notes
Regulation .11-1 adopted effective May 1, 2008 (35:8 Md. R. 809)
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.