1703.5 - Labeling
Where materials or assemblies are required by this code to be labeled, such materials and assemblies shall be labeled by an approved agency in accordance with Section 1703. Products and materials required to be labeled shall be labeled in accordance with the procedures set forth in Sections 1703.5.1 through 1703.5.3.
1703.5.1
Testing. An
approved
agency shall test a representative
sample of the product or material being labeled to the
relevant standard or standards. The approved
agency shall maintain a record of the tests performed. The
record shall provide sufficient detail to verify compliance with the test
standard.
1703.5.2
Inspection and identification. The approved
agency shall periodically perform an inspection, which shall
be in-plant if necessary, of the product or material that is to be
labeled. The inspection shall verify that the labeled product
or material is representative of the product or material tested.
1703.5.3
Label information. The
label shall contain the manufacturer's or distributor's
identification, model number, serial number or definitive information
describing the product or material's performance characteristics and
approved
agency's identification.
Notes
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.