Mich. Admin. Code R. 408.42155 - Specifications for stair rail
Rule 2155.
(1) A
stair railing shall consist of a stair rail, a vertical support, and an
intermediate rail or its equivalent to prevent an employee from falling through
the opening between the stair rail and the stairs. The stair rail shall
parallel the slope of the stairway.
(2) A stair rail shall be smooth, made of 2-
by 4-inch nominal-sized lumber, and constructed in a manner to withstand a side
thrust of not less than 200 pounds. The height of a stair rail shall be as
follows:
(a) A stair rail that is installed
after March 15, 1991, shall be not less than 36 inches (91.5 cm) from the upper
surface of the stair rail system to the surface of the tread and in line with
the face of the riser at the forward edge of the tread.
(b) A stair rail that is installed before
March 15, 1991, shall be not less than 30 inches (76 cm) nor more than 34
inches (86 cm) from the upper surface of the stair rail system to the surface
of the tread and in line with the face of the riser at the forward edge of the
tread.
(3) The vertical
post shall be constructed of not less than 2- by 4-inch nominal-sized lumber
and shall be spaced not more than 6 feet (1.8 m) apart.
(4) An intermediate rail or midrail shall be
constructed of not less than 1- by 6-inch or 2- by 4-inch nominal-sized lumber
and shall be installed midway between the stair rail and the treads.
(5) Screens, mesh, intermediate vertical
members, or equivalent intermediate structural members shall be provided
between the top rail of the stair rail system and the stairway steps.
(6) Screens or mesh, when used, shall extend
from the top rail to the stairway step and along the entire opening between the
top rail supports.
(7) When
intermediate vertical members, such as balusters, are used between posts, they
shall be not more than 19 inches (48 cm) apart.
(8) Other structural members, when used,
shall be installed such that there are no openings in the stair rail system
that are more than 19 inches (48 cm) wide.
(9) A stair rail shall not have protruding
nails or rough or sharp corners and shall not constitute a projection
hazard.
(10) Other material may be
used if the stair railing meets the 200-pound side thrust
requirement.
(11) A stairway that
has 4 or more risers or rises more than 30 inches (76 cm), whichever is less,
shall be equipped with at least 1 handrail and at least 1 stair rail system
along each unprotected side or edge. When the top edge of a stair rail system
also serves as a handrail,
R
408.42156(3) applies.
(12) Winding and spiral stairways shall be
equipped with a handrail that is sufficiently offset to prevent walking on
those portions of the stairways where the tread width is less than 6 inches (15
cm).
Notes
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.