Ohio Admin. Code 3745-266-109 - Low risk waste exemption

(A) Waiver of the destruction and removal efficiency standard. The destruction and removal efficiency standard of paragraph (A) of rule 3745-266-104 of the Administrative Code does not apply if the boiler or industrial furnace is operated in conformance with paragraph (A)(1) of this rule and the owner or operator demonstrates by procedures prescribed in paragraph (A)(2) of this rule that the burning will not result in unacceptable adverse health effects.
(1) The device must shall be operated as follows:
(a) A minimum of fifty per cent of fuel fired to the device must shall be fossil fuel, fuels derived from fossil fuel, tall oil, or, if approved by the director on a case-by-case basis, other nonhazardous fuel with combustion characteristics comparable to fossil fuel. Such fuels are termed "primary fuel" for purposes of this rule. (Tall oil is a fuel derived from vegetable and rosin fatty acids.) The fifty per cent primary fuel firing rate must shall be determined on a total heat or mass input basis, whichever results in the greater mass feed rate of primary fuel fired;
(b) Primary fuels and hazardous waste fuels must shall have a minimum as-fired heating value of eight thousand British thermal units (Btu) per pound;
(c) The hazardous waste is fired directly into the primary fuel flame zone of the combustion chamber; and
(d) The device operates in conformance with the carbon monoxide controls provided by paragraph (B)(1) of rule 3745-266-104 of the Administrative Code. Devices subject to the exemption provided by this rule are not eligible for the alternative carbon monoxide controls provided by paragraph (C) of rule 3745-266-104 of the Administrative Code.
(2) Procedures to demonstrate that the hazardous waste burning will not pose unacceptable adverse public health effects are as follows:
(a) Identify and quantify those nonmetal compounds listed in the appendix to rule 3745-51-11 of the Administrative Code that could reasonably be expected to be present in the hazardous waste. The constituents excluded from analysis must shall be identified and the basis for their the exclusion of such constituents shall be explained;
(b) Calculate reasonable, worst case emission rates for each constituent identified in paragraph (A)(2)(a) of this rule by assuming the device achieves 99.9 per cent destruction and removal efficiency. That is, assume that 0.1 per cent of the mass weight of each constituent fed to the device is emitted.
(c) For each constituent identified in paragraph (A)(2)(a) of this rule, use emissions dispersion modeling to predict the maximum annual average ground level concentration of the constituent.
(i) Dispersion modeling must shall be conducted using methods specified in paragraph (H) of rule 3745-266-106 of the Administrative Code.
(ii) Owners and operators of facilities with more than one on-site stack from a boiler or industrial furnace that is exempt under this rule must shall conduct dispersion modeling of emissions from all stacks exempt under this rule to predict ambient levels prescribed by paragraphs (A) to (A)(2)(d)(iii) of this rule.
(d) Ground level concentrations of constituents predicted under paragraph (A)(2)(c) of this rule must shall not exceed the following levels:
(i) For the noncarcinogenic compounds listed in appendix I A to this rule, the levels established in appendix I A to this rule;
(ii) For the carcinogenic compounds listed in appendix II B to this rule, the sum for all constituents of the ratios of the actual ground level concentration to the level established in appendix II B to this rule cannot exceed 1.0; and
(iii) For constituents not listed in appendix I A or appendix II B to this rule, 0.1 micrograms per cubic meter.
(B) Waiver of particulate matter standard. The particulate matter standard of rule 3745-266-105 of the Administrative Code does not apply if:
(1) The destruction and removal efficiency standard is waived under paragraph (A) of this rule; and
(2) The owner or operator complies with the "Tier I" or "Adjusted Tier I" metals feed rate screening limits provided by paragraph (B) or (E) of rule 3745-266-106 of the Administrative Code.

Click to view Appendix

Click to view Appendix

Notes

Ohio Admin. Code 3745-266-109
Effective: 10/31/2015
Five Year Review (FYR) Dates: Exempt
Promulgated Under: 119.03
Statutory Authority: 3734.12
Rule Amplifies: 3734.12
Prior Effective Dates: 12/07/2004, 09/05/2010

State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.


No prior version found.