Or. Admin. Code § 918-674-0130 - Insignia(s) of Compliance Required
(1) Each prefabricated structure, except as
required in sections (2), (3) and (4) of this rule, manufactured for sale,
lease, rent or installation in Oregon shall bear an Oregon insignia of
compliance affixed to each section or module, located on an accessible exterior
wall or according to the approved plans, prior to leaving the manufacturing
plant.
(2) Each prefabricated
component building manufactured for sale or installed in Oregon shall bear an
Oregon insignia of compliance located on an accessible exterior wall prior to
leaving the manufacturing plant.
(3) Prefabricated refrigeration panels
manufactured for sale or installed in Oregon shall bear one Oregon insignia of
compliance located on the exterior side of the panel located nearest the door
prior to leaving the manufacturing plant.
(4) Each prefabricated building component not
identified in section (2) or (3) of this rule, manufactured for sale or
installed in Oregon, shall bear one Oregon insignia of compliance located in a
conspicuous place prior to leaving the manufacturing plant.
(5) The application shall be submitted to the
Division's Salem office accompanied by the appropriate insignia fees and must
be received prior to construction.
(6) Only an Oregon certified third-party
agency may issue Oregon insignias of compliance to prefabricated structure
suppliers or manufacturers for those prefabricated structures inspected by that
third-party agency.
(7)
Manufacturers shall order insignias of compliance on Division-supplied forms
for any prefabricated structures to be inspected by the Division or a
third-party agency at the fees described in OAR
918-674-0155.
(8) Third-party agencies shall designate at
least one individual, but not more than two individuals, in their organization
authorized to receive insignias of compliance. The Division shall only issue
insignias of compliance to the person(s) authorized by the
third-party.
(9) Upon receipt, the
third-party agency shall verify the insignias of compliance have been received
in satisfactory condition and contain the correct information. Any insignias of
compliance damaged or containing incorrect information shall be returned to the
Division immediately for replacement.
(10) A third-party agency is responsible for
an insignia of compliance from the time it is received until it is issued to
the manufacturer. The third-party agency shall insure insignias of compliance
are secured under lock and key until issued.
(11) No insignia shall be issued by a
third-party for any prefabricated structure prior to plans being approved and
inspections made verifying compliance with the Oregon Specialty Codes
and these rules.
(12) All
insignias of compliance remain the sole property of the Division and may be
withdrawn from the manufacturer or third-party upon cause.
(13) When a manufacturer's registration has
been canceled by the Division, the third-party agency shall not issue any
insignias of compliance to that manufacturer.
Notes
Publications: The publications referred to or incorporated by reference in this rule are available from the agency.
Stat. Auth.: ORS 455.030, ORS 455.100 & ORS 455.110
Stats. Implemented: ORS 455.110 & ORS 455.705
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.