The owner or operator of a waste oil processing or
rerefining facility shall develop and follow a written analysis plan describing
the procedures that will be used to comply with the analysis requirements of
§
298.53 (relating to rebuttable
presumption for waste oil and flashpoint screening) and, if applicable, §
298.72 (relating to
on-specification waste oil fuel). The owner or operator shall keep the plan at
the facility.
(1)
Rebuttable
presumption for waste oil and flash point screening in § 298.53.
At a minimum, the plan shall specify the following:
(i) Whether sample analyses or knowledge of
the halogen content of the waste oil will be used to make this
determination.
(ii) If sample
analyses are used to make this determination:
(A) The sampling method used to obtain
representative samples to be analyzed. A representative sample may be obtained
using either:
(I) One of the sampling methods
in 40 CFR Part
261 , Appendix I (relating to representative sampling methods)
incorporated by reference in §
261a.1 (relating to incorporation
by reference, purpose and scope).
(II) A method shown to be equivalent under
40 CFR
260.20 and
260.21 (relating to general; and
petitions for equivalent testing or analytical methods), incorporated by
reference in §
260a.1 (relating to incorporated
by reference, purpose, scope and applicablity).
(B) The frequency of sampling to be
performed, and whether the analysis will be performed onsite or
offsite.
(C) The methods used to
analyze waste oil for the parameters specified in § 298.53.
(iii) The type of information that
will be used to determine the halogen content of the waste oil.
(2)
On-specification waste
oil fuel in §
298.72
. At a minimum,
the plan shall specify the following if § 298.72 applies:
(i) Whether sample analyses or other
information will be used to make this determination.
(ii) If sample analyses are used to make this
determination:
(A) The sampling method used
to obtain representative samples to be analyzed. A representative sample may be
obtained using one of the following:
(I) One
of the sampling methods in 40 CFR Part
261 , Appendix I, incorporated by
reference in § 261a.1.
(II) A
method shown to be equivalent under
40 CFR
260.20 and
260.21 incorporated by reference
in § 260a.1.
(B)
Whether waste oil will be sampled and analyzed prior to or after any waste oil
processing/rerefining.
(C) The
frequency of sampling to be performed and whether the analysis will be
performed onsite or offsite.
(D)
The methods used to analyze waste oil for the parameters specified in §
298.72.
(iii) The type of
information that will be used to make the onspecification waste oil fuel
determination.