010-52 Wyo. Code R. §§ 52-4 - Standards of Quality
(a) Exceptions to
ASTM standards for fuel oil:
(i) ASTM grades
No. 1 and No. 2 shall not have a flash point lower than one hundred fifteen
degrees Fahrenheit (115@ F).
(ii)
ASTM grades No. 4, No. 5 and No. 6 shall not exceed one and one-half percent
(1.5%) sulfur by weight.
(b) Exceptions to ASTM standards for diesel
fuel:
(i) ASTM grade No. 1 shall be a clear
product free of water and sediment.
(c) Exceptions to ASTM standards for
gasoline:
(i) Gasoline shall be a clear
homogeneous liquid free of water and sediment;
(ii) The minimum lead content for gasoline
labeled "regular" or "leaded" shall be as defined in Section
2.(e) of this chapter.
(iii) Requirements imposed by the EPA shall
take precedence over ASTM standards, where applicable.
(iv) The allowable reductions in vehicle anti
knock requirements for altitude are 4.5 for less than 89 Antiknock Index (AKI),
and 3.0 for greater than 89 AKI. Fuel may be marketed using these reductions,
but actual AKI minimum must be posted.
(d) Exceptions to ASTM standards for
kerosene:
(i) Kerosene shall be free of water
and suspended material.
(ii)
Kerosene shall have a color no darker than No. 16 Saybolt.
(iii) Kerosene shall have a flash point not
lower than one hundred fifteen degrees Fahrenheit (115@ F).
Notes
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.