020-3 Wyo. Code R. §§ 3-18 - Supporting Documentation/Appendices
(a) A USGS
topographic map with a scale of 1:24,000 showing the proposed facility location
or, if a 1:24,000 map is unavailable, USGS topographic map with a scale of
1:62,500 or another suitable topographic map.
(b) A map or aerial photograph of the area
showing land ownership, land use, and zoning within one mile of the disposal
site. The map or photograph shall be of sufficient scale to show all city
boundaries, occupied dwelling, schools, hospitals, industrial buildings, water
wells, water courses, roads, and other applicable details.
(c) A general facility plot plan (map) with a
scale and contour intervals approved by the Administrator. The general facility
plot plan shall at a minimum illustrate the following features:
(i) Landfill facility boundaries;
(ii) Points of access;
(iii) Location of soil borings and monitoring
wells;
(iv) Location of proposed
trenches or area fill locations;
(v) Working area/perimeter fire
lane;
(vi) Working area/perimeter
fence location; and
(vii) Locations
of any facility buildings at the landfill.
(d) Additional facility plot plans at the
same scale as the general facility plot plan, shall be submitted as necessary
to show orderly development and use of the facility through the life of the
site. These plot plans shall at a minimum contain the following information:
(i) Excavation plans for development of
trenches or preparation of area fill locations;
(ii) Development of temporary surface water
diversion structures which may be necessary to adequately control surface water
run-on and run-off;
(iii) Access to
active solid waste disposal areas, including development of internal
roads;
(iv) Cover stockpile
locations;
(v) Topsoil storage pile
locations;
(vi) Litter screen
placement information, if applicable;
(vii) Location of special waste management or
disposal areas, if applicable; and
(viii) Other details pertinent to the
development and use of the facility.
(e) A map showing proposed final post-closure
contours prepared at the same scale as the general facility plot
plan.
(f) If the industrial solid
waste facility is included in a larger industrial property, a map that shows
the facility boundaries in relation to the overall boundaries of the industrial
property.
(g) Cross sections or
drawing with sufficient specifications to describe:
(i) Internal litter catch screens or fences,
if applicable;
(ii) Working
area/perimeter fencing;
(iii)
Access roads;
(iv) Trench or area
fill method;
(v) Special waste
areas, where appropriate;
(vi)
Systems used for monitoring, collection, treatment, and disposal of leachate,
if applicable;
(vii) Groundwater
monitoring well design;
(viii)
Methane gas venting and monitoring system, if applicable;
(ix) Surface and subsurface drain systems to
control run-on, run-off and, inflow;
(x) All components of engineered containment
systems, if applicable, which include, but are not limited to, liners, caps,
and berms; and
(xi) Any other
design details requested by the Administrator.
(h) Recordkeeping logs: A copy of the
recordkeeping logs/forms that will be maintained during the operating life,
closure, and post-closure maintenance period.
Notes
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.