25 Pa. Code § 288.133 - Map and grid requirements
(a) An
application shall contain a topographic map of the proposed permit and adjacent
areas showing the following:
(1) The
boundaries of lands proposed to be affected over the estimated total life of
the proposed operation and the sequence of landfilling and closure.
(2) A change in a component of the facility
or a feature within the proposed permit area to be caused by the proposed
operation.
(3) The buildings,
utility corridors and facilities which will be used in the operation.
(4) The areas of land for which a bond will
be posted under Chapter 287, Subchapter E (relating to bonding and insurance
requirements).
(5) The solid waste
storage, processing or unloading areas.
(6) The water diversion, collection,
conveyance, erosion and sedimentation control, treatment, storage and discharge
facilities to be used.
(7) The
location and elevation of the permanent physical markers for the grid
coordinate system under subsection (b).
(8) The gas management, collection and
control facilities, if required.
(9) The boundaries of construction
activities.
(10) The location of
barriers, fences and similar structures required by §
288.212 (relating to access
control).
(11) The location of each
sedimentation pond, permanent water impoundment or similar facility.
(12) The location of access roads to the
site, including slopes, grades and lengths of the roads.
(13) The location and identity of monitoring
wells.
(14) For noncaptive residual
waste landfills, a designated area for vehicles for use in the event of the
detection of waste containing radioactive material. The designated area shall,
by location or shielding, protect the environment, facility staff and public
from radiation originating in the vehicle. The Department's "Guidance
Document on Radioactivity Monitoring at Solid Waste Processing and Disposal
Facilities," Document Number 250-3100-001, describes various factors
to consider in determining an appropriate designated area.
(b) The applicant shall also submit a grid
coordinate system for the entire proposed permit area. The horizontal control
system shall consist of a grid not to exceed 200-foot square sections unless
the facility is larger than 250 acres and the Department approves, in writing,
a grid that exceeds 200-foot square sections. A permanent benchmark for
horizontal and vertical control shall be shown. The grid system shall be a
state or universal grid system and shall be tied to the benchmark and the
baseline.
Notes
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.